Home ReviewsRefund
Home/Nissan/Note/Nissan Note E12 (2012-2016)/Repair manual/Engine Control Systems/Accelerator Control System: Removal & Installation
Contents Wiring diagrams Section: Engine Control Systems All sections

Accelerator Control System: Removal & Installation Nissan Note E12

Engine Control Systems 1 illustration

INSTALLATION

Installation is in the reverse order of removal.

Note. Insert locating pin into brake pedal bracket to position accelerator pedal. Perform accelerator pedal inspection. Refer to " INSPECTION ".

Scheme 1

Scheme 1: INSPECTION AFTER INSTALLATION
Scheme 1: INSPECTION AFTER INSTALLATION
  1. Check that the accelerator pedal moves smoothly within the specified range. Accelerator pedal stroke (A): Refer to " «ACCELERATOR CONTROL»(ref-675602-S35002424352014120500000) ".
  2. Check the accelerator pedal height. Accelerator pedal height: Refer to " «ACCELERATOR CONTROL»(ref-675602-S35002424352014120500000) ".
CAUTIONWhenever the harness connector of the accelerator pedal position sensor has been disconnected, perform " ACCELERATOR PEDAL RELEASED POSITION LEARNING ". Refer to " WORK PROCEDURE ". The accelerator pedal should return smoothly to the fully released position.

Unit: mm (in) Accelerator pedal stroke (A) 49.8 - 52.6 (1.96 - 2.07) Accelerator pedal height 113.0 - 123.0 (4.45 - 4.84)

More articles — Accelerator Control System