CONSULT-III APPLICATION ITEMS
CONSULT-III can perform the following diagnosis modes via CAN communication and the combination meter.
| System | Diagnosis mode | Description |
|---|---|---|
| METER/M&A | Self Diagnostic Result | The combination meter checks the conditions and displays memorized errors. |
| Data Monitor | Displays the combination meter input/output data in real time. | |
| Special function | Lighting history of the warning lamp and indicator lamp can be checked. |
CONSULT-III FUNCTION CHART
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
| Diagnosis mode | Function Description |
|---|---|
| Work Support | Changes the setting for each system function. |
| Self Diagnostic Result | Displays the diagnosis results judged by BCM. |
| CAN Diag Support Monitor | Monitors the reception status of CAN communication viewed from BCM. Refer to CONSULT-III operation manual. |
| Data Monitor | The BCM input/output signals are displayed. |
| Active Test | The signals used to activate each device are forcibly supplied from BCM. |
| Ecu Identification | The BCM part number is displayed. |
| Configuration | Read and save the vehicle specification. Write the vehicle specification when replacing BCM. |
CONSULT-III FUNCTIONS CHART
SYSTEM APPLICATION
BCM can perform the following functions for each system.
Note. It can perform the diagnosis modes except the following for all sub system selection items.
| X: Applicable item | ||||
|---|---|---|---|---|
| System | Sub system selection item | Diagnosis mode | ||
| Work Support | Data Monitor | Active Test | ||
| Door lock | DOOR LOCK | X | X | X |
| Rear window defogger | REAR DEFOGGER | X | X | |
| Warning chime | BUZZER | X | X | |
| Interior room lamp timer | INT LAMP | X | X | X |
| Exterior lamp | HEAD LAMP | X | X | X |
| Wiper and washer | WIPER | X (1) | X | X |
| Turn signal and hazard warning lamps | FLASHER | X | X | X |
| AIR CONDITIONER (2) | ||||
| Intelligent Key system Engine start system | INTELLIGENT KEY | X | X | X |
| Combination switch | COMB SW | X | ||
| Body control system | BCM | X | ||
| NVIS - NATS | IMMU | X | X | |
| Interior room lamp battery saver | BATTERY SAVER | X | X | X |
| Back door opener system | TRUNK | X | X | |
| Vehicle security system | THEFT ALM | X | X | X |
| RAP system | RETAINED PWR | X | ||
| Signal buffer system | SIGNAL BUFFER | X | X | |
| TPMS | TPMS (AIR PRESSURE MONITOR) | X | X | X |
| (1) For models with rain sensor this mode is displayed, but is not used. (2) This item is displayed, but is not used. | ||||
| (1) | For models with rain sensor this mode is displayed, but is not used. |
| (2) | This item is displayed, but is not used. |
SUB SYSTEM SELECTION ITEMS REFERENCE CHART
| Test item | Diagnosis mode | Description |
|---|---|---|
| BUZZER | Data Monitor | Displays BCM input data in real time. |
| Active Test | Operation of electrical loads can be checked by sending driving signal to them. |
DIAGNOSIS MODE DESCRIPTION CHART