Home ReviewsRefund
Home/Nissan/Murano/Nissan Murano Z51 рестайлинг 2 (2011-2015)/Repair manual/Steering Control Systems/Steering Control System (Except Crosscabriolet): Overview
Contents Section: Steering Control Systems All sections

Steering Control System (Except Crosscabriolet): Overview Nissan Murano Z51 рестайлинг 2

Steering Control Systems 2 illustrations ~388 words

Component Description

Component partsReference/Function
Power steering control unitSignals from various sensors control the driving voltage to the power steering solenoid valve. The power steering control unit controls the driving voltage to the power steering solenoid valve for maintaining the power steering assist force when the fail-safe function is activated. (The engine speed signals control EPS system if any vehicle speed signal error is detected.)
Combination meter" DESCRIPTION "
ECM" DESCRIPTION "
Power steering solenoid valve" DESCRIPTION "

Description

Power supply to EPS system

Power steering solenoid valve controls the power steering oil pressure in the gear housing assembly.

ECM sends engine speed signal to power steering control unit.

Combination meter sends vehicle speed signal to power steering control unit.

Scheme 1

Scheme 1: Diagnosis Procedure
Scheme 1: Diagnosis Procedure
  1. PERFORM COMBINATION METER SELF-DIAGNOSIS With CONSULT Turn the ignition switch ON. CAUTION: Never start the engine Perform "METER/M&A" self-diagnosis. Refer to " «CONSULT FUNCTION (METER/M&A)»(ref-593965-S06714263712014012200000) ". Is any DTC detected? YES: Check the DTC. NO: GO TO 2.
  2. CHECK HARNESS BETWEEN COMBINATION METER AND POWER STEERING CONTROL UNIT Turn the ignition switch OFF. Disconnect combination meter harness connector. Disconnect power steering control unit harness connector. Check continuity between combination meter harness connector and power steering control unit harness connector. Combination meter Power steering control unit Continuity Connector Terminal Connector Terminal M34 30 M61 8 Existed Check continuity between power steering control unit harness connector and ground. Power steering control unit - Continuity Connector Terminal M61 8 Ground Not existed Is the inspection result normal? YES: GO TO 3. NO: Repair or replace damaged parts.
  3. CHECK VEHICLE SPEED SIGNAL (1) Turn the ignition switch OFF. Connect combination meter harness connector. Check combination meter input/output standard values. Refer to " «REFERENCE VALUE»(ref-593965-S29060378282014012200000) ". Is the inspection result normal? YES: GO TO 4. NO: Replace combination meter Refer to " «EXPLODED VIEW»(ref-593965-S31532450902014012200000) ".
  4. CHECK VEHICLE SPEED SIGNAL (2) Turn the ignition switch OFF. Connect power steering control unit harness connector. Check signal between power steering control unit harness connector and ground with oscilloscope. Power steering control unit - Condition Voltage (Approx.) Connector Terminal M61 8 Ground Vehicle speed: 40 km/h (25 MPH) CAUTION: Check air pressure of tire under standard condition. NOTE: The maximum voltage varies depending on the specification (destination unit). Is the inspection result normal? YES: GO TO 5. NO: Replace power steering control unit. Refer to " «REMOVAL AND INSTALLATION»(ref-593981-S36508818202014012200000) ".
  5. CHECK TERMINALS AND HARNESS CONNECTORS Check power steering control unit pin terminals for damage or loose connection with harness connector. Check combination meter pin terminals for damage or loose connection with harness connector. Is the inspection result normal? YES: INSPECTION END NO: Repair or replace damaged parts.

Scheme 2

Scheme 2: TERMINAL LAYOUT
Scheme 2: TERMINAL LAYOUT
  1. Hard steering when fully turning the steering wheel.
  2. Light steering when driving at a high speed.

More articles — Steering Control System (Except Crosscabriolet)