Home ReviewsRefund
Home/Nissan/Maxima/Nissan Maxima A34 (2003-2008)/Repair manual/Manual Transaxle/FILLING
Contents Wiring diagrams Section: Manual Transaxle All sections

FILLING Nissan Maxima A34

Manual Transaxle 2 illustrations ~190 words

FILLING

  1. Remove speedometer pinion gear. Fill the transaxle with new oil. Oil grade and capacity: Refer to «FLUIDS AND LUBRICANTS»(ref-233644-S09981660282006052600000) .
  2. After refilling oil, check oil level. Assemble a new o-ring on to the speedometer pinion gear, then install it in transaxle case. Speedometer pinion gear: 4.9 - 6.8 N.m (0.5 - 0.7 kg-m, 43 - 61 in-lb) CAUTION: Do not reuse o-ring.

Scheme 74

Scheme 74: OIL LEAKAGE AND OIL LEVEL
Scheme 74: OIL LEAKAGE AND OIL LEVEL
  1. Check that oil is not leaking from transaxle.
  2. Remove speedometer pinion gear.
  3. Measure oil level using suitable gauge as shown, and check if "L" is within the specifications. Oil level "L": 49 - 55 mm (1.93 - 2.17 in) CAUTION: Never start engine while checking oil level.
  4. Set a new o-ring on the speedometer pinion gear and install it in the transaxle case. Speedometer pinion gear: 4.9 - 6.8 N.m (0.5 - 0.7 kg-m, 43 - 61 in-lb) CAUTION: Do not reuse o-ring.

Scheme 75

Scheme 75: REMOVAL
Scheme 75: REMOVAL
  1. Remove the drive shaft from the transaxle case. Refer to «REMOVAL AND INSTALLATION»(ref-233652-S33721208742006052600000) .
  2. Remove the oil seal with a slotted screwdriver as shown. CAUTION: Be careful not to damage the transaxle case surface when removing the oil seal.