REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION before disconnecting battery. |
Refer to , for removal and installation of door trim.
- Remove inside handle escutcheon. (Scheme 9)
- Remove power window switches, then disconnect the connectors.
- Remove screw securing pull handle, then remove pull handle.
- Remove step lamp lens and two screws securing step lamp, and then disconnect step lamp connector.
- Remove two screws.
- Remove clips (C101) securing door finisher.
- Lift out door finisher. Disconnect harness connectors.
- To install, reverse removal procedure.
Scheme 9
- Remove door trim. See «DOOR TRIM»(ref-141748-S01176752212002070500000).
- Remove inner cover front corner of door. (Scheme 10)
- Disconnect door mirror harness connector. (Scheme 10)
- To install, reverse removal procedures.
