INSTALLATION
- The dam sealant rubber should be installed in position.
- Use a genuine Nissan Urethane Adhesive Kit (if available) or an equivalent and follow the instructions provided with it.
- Open a door window while the urethane adhesive is curing. This prevents the glass from being forced out by passenger room air pressure when all door windows are closed.
- Inform the customer that the vehicle should remain stationary until the urethane adhesive is completely cured (approximately 24 hours). Curing time varies with temperature and humidity.
| WARNING | Keep heat and open flames away as primers and adhesive are flammable. The materials contained in the kit are harmful if swallowed, and may irritate skin and eyes. Never let them come in contact with the skin and eyes. Use in an open, well ventilated location. Never breathe the vapors. They may be harmful if inhaled. Move immediately to an area with fresh air if affected by vapor inhalation. Driving the vehicle before the urethane adhesive is completely cured may affect the performance of the windshield in an accident. |
| CAUTION | Perform adjustment of front wiper arms stop location. Refer to " ADJUSTMENT ". Never use an adhesive that is past its usable term. Shelf life of this product is limited to six months after the date of manufacture. Read the expiration or manufacture date printed on the box. Keep primers and adhesive in a cool, dry place. Ideally, they should be stored in a refrigerator. Never leave primers or adhesive cartridge unattended with their caps open or off. The vehicle should not be driven for 24 hours or more or until the urethane adhesive is completely cured. Curing time varies depending on temperature and humidity. The curing time increases under lower temperature and lower humidity. |
- The dam sealant rubber should be installed in position.
- Use a Genuine Nissan Urethane Adhesive Kit (if available) or an equivalent and follow the instructions provided with it.
- Open a door window while the urethane adhesive is curing. This prevents the glass from being forced out by passenger compartment air pressure when all door windows are closed.
- The molding must be installed securely so that it is in position and leaves no clearance.
- Inform the customer that the vehicle should remain stationary until the urethane adhesive is completely cured (approximately 24 hours). Curing time varies with temperature and humidity. WARNING: Keep heat and open flames away as primers and adhesive are flammable. The materials contained in the kit are harmful if swallowed, and may irritate skin and eyes. Never let them come in contact with the skin and eyes. Use in an open, well ventilated location. Never breathe the vapors. They may be harmful if inhaled. Move immediately to an area with fresh air if affected by vapor inhalation. Driving the vehicle before the urethane adhesive is completely cured may affect the performance of the back door window in an accident. CAUTION: Perform adjustment of rear wiper arm stop location. Refer to " «ADJUSTMENT»(ref-621435-S28941624542014061000000) ". Never use an adhesive that is past its usable term. Shelf life of this product is limited to six months after the date of manufacture. Read carefully the expiration or manufacture date printed on the box. Keep primers and adhesive in a cool, dry place. Ideally, they should be stored in a refrigerator. Never leave primers or adhesive cartridge unattended with their caps open or off. The vehicle should not be driven for 24 hours or more or until the urethane adhesive is completely cured. Curing time varies depending on temperature and humidity. The curing time increases under lower temperature and lower humidity.
Install in the reverse order of removal.
Install in the reverse order of removal.
Install in the reverse order of removal.
REMOVAL
- Remove rear door glass. Refer to " «REMOVAL AND INSTALLATION»(ref-621433-S07076563582014061000000) ".
- Disconnect the power window motor harness connector.
- Remove rear door regulator mounting bolts and then remove rear door regulator from door panel.
- Remove lower sash (front) mounting bolt and then remove lower sash (front) from rear door panel.
Install in the reverse order of removal.