Nissan Frontier D22 (1998-2007) gnd sig Wiring diagram

+IG AT DEVICE BLK WIRE BLU WIRE BODY CONTROL MODULE (BCM) (UNDER CENTER OF DASH) BRN WIRE CAN-H CAN-L CAN-H CLUTCH CARGO INTERLOCK LAMP CANCEL SWITCH SWITCH (IF EQUIPPED) COMB SW IN 1 COMB SW IN 2 COMB SW IN 3 COMB SW IN 4 COMB SW OUT 1 COMB SW OUT 2 COMB SW OUT 3 COMB SW OUT 4 COMB SW OUT 5 COMBINATION METER COMBINATION SWITCH CONTROL CPU TAIL/L RLY FUSE DIFFERENTIAL LOCK SWITCH (W/ ELECTRONIC LOCKING REAR DIFFERENTIAL) DOOR MIRROR REMOTE CONTROL SWITCH ELECTRIC BRAKE (PRE-WIRING) EQUIPPED) FRONT AIR FUSE FUSE 1 FUSE 19 FUSE BLOCK (J/B) (UNDER RIGHT SIDE OF DASH) FUSE, FUSIBLE LINK BOX (RIGHT REAR OF ENGINE COMPARTMENT) FUSIBLE LINK G GND BAT (F/L) GND PWR GND SIG GRN WIRE GRY WIRE HAZARD AUDIO ILL SWITCH UNIT (IF EQUIPPED) GND HOT AT ALL TIMES HOT IN ON OR START IGN SW IGNITION RELAY INPUT 1 INPUT 2 INPUT 3 INPUT 4 INPUT 5 IPDM E/R (RIGHT REAR OF ENGINE COMPARTMENT) LEFT FRONT HEATED SEAT SWITCH (IF HDC SWITCH (W/ VDC) LT BLU WIRE LT GRN WIRE ORG/ WIRE OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 PNK CAN-L WIRE PNK COMB SW IN 5 WIRE PNK DATA LINK CONNECTOR WIRE PNK OUTPUT 5 WIRE PNK WIRE RED WIRE RED/YEL WIRE RIGHT FRONT HEATED SEAT SWITCH (IF VDC OFF SWITCH (W/ VDC) SHIFT SWITCH (4 WHEEL DRIVE) TAIL LAMP RELAY UNIFIED METER CONTROL UNIT VIO WIRE WHT WIRE WHT/RED WIRE