COIL Nissan Armada I

COIL

Check magnet coil for loose connections or any cracked insulation.

Scheme 304

Scheme 305

Scheme 306

Scheme 307

Scheme 308

1. Install the magnet coil. CAUTION: Be sure to align the magnet coil pin with the hole in the compressor front head.
2. Install the magnet coil harness clip using a screwdriver.
3. Install the pulley assembly using Tool and a wrench, then install the snap ring using snap ring pliers. Tool number: - (J-38873-A)
4. Install the clutch disc on the compressor shaft, together with the original shim(s). Press the clutch disc down by hand.
5. Install the clutch pulley bolt using Tool, to prevent the clutch disc from turning and tighten the bolt to specification. Tool number: J-44614 CAUTION: After tightening the clutch pulley bolt, check that the clutch pulley rotates smoothly.
6. Check the pulley clearance all the way around the clutch disc (Scheme 308) Clutch disc-to-pulley clearance: 0.3 - 0.6 mm (0.012-0.024 in)
7. If the specified clearance is not obtained, replace the adjusting spacer to readjust.
8. Connect the compressor electrical connector.
9. Install the drive belt. Refer to «DRIVE BELTS»(ref-233240-S28365612942006052500000)
10. Install the engine under cover and the splash shield.