Home ReviewsRefund
Home/Nissan/Altima/Nissan Altima L33 (2012-2015)/Repair manual/Engine Control Systems/Accelerator Control System (Sedan): Removal & Installation
Contents Wiring diagrams Section: Engine Control Systems All sections

Accelerator Control System (Sedan): Removal & Installation Nissan Altima L33

Engine Control Systems 1 illustration ~105 words

REMOVAL

  1. Disconnect the harness connector from accelerator pedal assembly.
  2. Remove the two accelerator pedal bolts.
  3. Remove the accelerator pedal assembly. CAUTION: Do not disassemble the accelerator pedal assembly. Do not drop or impact the accelerator pedal assembly. Do not expose the accelerator pedal assembly to water.

INSTALLATION

Installation is in the reverse order of removal.

  1. Check the accelerator pedal moves smooth within the specified range.

Accelerator pedal stroke (A): Refer to " ACCELERATOR CONTROL ".

Scheme 1

Scheme 1
Scheme 1
CAUTIONWhenever the harness connector of the accelerator pedal position sensor is disconnected, perform the "Accelerator pedal released position learning". Refer to " WORK PROCEDURE " (QR25DE) or " WORK PROCEDURE " (VQ35DE). The accelerator pedal should return smoothly to the fully raised position.

Unit: mm (in) Accelerator pedal stroke (A) 50.5 - 53.5 (1.99 - 2.11)

See also:
• WORK PROCEDURE
• WORK PROCEDURE

More articles — Accelerator Control System (Sedan)