Home/Nissan/Altima/Nissan Altima L33 (2012-2015)/Repair manual/Engine Control System (Introduction) (California) (Coupe): Overview/SET OPERATION

Contents

Wiring diagrams Section: Engine Control System (Introduction) (California) (Coupe): Overview

System Description

Component Description

SET OPERATION

ACCELERATE OPERATION

CANCEL OPERATION

COAST OPERATION

RESUME OPERATION

Cooling Fan Relay Operation

Reset Operation

Diagnosis Description

DIAGNOSIS DESCRIPTION: 1st Trip Detection Logic and Two Trip Detection Logic

DIAGNOSIS DESCRIPTION: Driving Pattern

DIAGNOSIS DESCRIPTION: System Readiness Test (SRT) Code

DIAGNOSIS DESCRIPTION: Permanent Diagnostic Trouble Code (Permanent DTC)

DIAGNOSIS DESCRIPTION: Malfunction Indicator Lamp (MIL)

DESCRIPTION

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: Description

IDLE SPEED: Description

IGNITION TIMING: Description

VIN REGISTRATION: Description

ACCELERATOR PEDAL RELEASED POSITION LEARNING: Description

THROTTLE VALVE CLOSED POSITION LEARNING: Description

IDLE AIR VOLUME LEARNING: Description

MIXTURE RATIO SELF-LEARNING VALUE CLEAR: Description

All sections

SET OPERATION Nissan Altima L33

Engine Control System (Introduction) (California) (Coupe): Overview

SET OPERATION

Press MAIN switch. (CRUISE is indicated on the information display.)

When vehicle speed reaches a desired speed between approximately 40 km/h (25 MPH) and 144 km/h (89 MPH), press SET/COAST switch. (Then SET is indicated on the information display.)