Accelerator Control System (Hybrid): Removal & Installation — Nissan Altima L32 рестайлинг (2009-2013)

Accelerator Control System (Hybrid): Removal & Installation Nissan Altima L32 рестайлинг

REMOVAL

Disconnect the 12-volt battery negative terminal.
Disconnect the accelerator position sensor electrical connector.
Remove the accelerator pedal nuts.
Remove the accelerator pedal assembly. For electrical inspection of the accelerator pedal position sensor. Refer to " «DESCRIPTION»(/nissan/altima/l32-2009-2013/remont/engine-control-systems/#hybrid-control-system-hybrid) ". CAUTION: Do not disassemble the pedal assembly. Avoid impact from dropping during handling. Keep the pedal assembly away from water.

Installation is in the reverse order of removal.

Scheme 3: INSTALLATION

Check the accelerator pedal for smooth operation. There should be no binding or sticking when applying or releasing the accelerator pedal.
Check that the accelerator pedal moves through the full specified distance of pedal travel. Pedal travel (A) : 51.1 mm (2.01 in)

CAUTION

When the harness connector of the accelerator pedal position sensor is disconnected, perform the "Accelerator pedal released position learning". Refer to " ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : SPECIAL REPAIR REQUIREMENT ".