Accelerator Control System (Except Hybrid): Removal & Installation Nissan Altima L32

REMOVAL

1. Disconnect the battery negative terminal.
2. Disconnect the accelerator position sensor electrical connector.
3. Remove the upper accelerator pedal nuts and lower accelerator pedal bolt.
4. Remove the accelerator pedal and accelerator position sensor assembly.

1. For electrical inspection of the accelerator pedal position sensor. Refer to " «COMPONENT INSPECTION»(/nissan/altima/l32-2006-2009/remont/engine-control-systems/#engine-control-system-qr25de-for-california) " (QR25DE), " «COMPONENT INSPECTION»(/nissan/altima/l32-2006-2009/remont/engine-control-systems/#engine-control-system-vq35de) " (VQ35DE). CAUTION: Do not disassemble the pedal assembly. Do not remove the accelerator pedal position sensor from the pedal assembly. Avoid impact from dropping during handling. Keep the pedal assembly away from water.

INSTALLATION

Installation is in the reverse order of removal.

Scheme 1

1. Check the accelerator pedal for smooth operation. There should be no binding or sticking when applying or releasing the accelerator pedal.
2. Check that the accelerator pedal moves through the full specified distance of pedal travel. Pedal travel "A": 44.3-51.1 mm (1.74-2.01 in) (Scheme 1): Checking Accelerator Pedal

See also:
• COMPONENT INSPECTION
• COMPONENT INSPECTION
• ACCELERATOR PEDAL RELEASED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT