Coil
Check magnet coil for loose connection or cracked insulation.
Scheme 267
Scheme 268
Scheme 269
Scheme 270
Scheme 271
- Install the magnet coil. Be sure to align the magnet coil pin with the hole in the compressor front head.
- Install the magnet coil harness clip using a screwdriver.
- Install the pulley assembly using the installer and a wrench, and then install the snap ring using snap ring pliers.
- Install the clutch disc on the drive shaft, together with the original shim(s). Press the clutch disc down by hand.
- Using the clutch disc tool to prevent clutch disc rotation, tighten the bolt to 12 N.m (1.2 kg-m, 9 ft-lb).
- After tightening the bolt, check that the pulley rotates smoothly.
- Check clearance all the way around the clutch disc. Clutch disc-to-pulley: 0.3 - 0.6 mm (0.012 - 0.024 in) clearance If the specified clearance is not obtained, replace adjusting spacer and readjust.