DISABLING & ACTIVATING AIR BAG SYSTEM
| WARNING | On models with driver-side air bag, use extreme caution while servicing steering column. Work from side of air bag module. Disconnect negative battery cable and wait 10 minutes to allow system to electrically discharge before attempting any repair. DO NOT apply electrical power to any component on steering column without disconnecting air bag module, or system may be activated. |
- To disable air bag, turn ignition switch to OFF position. Disconnect and shield negative battery cable and then positive battery cable. Wait at least 10 minutes before working on or near air bag components.
- To activate system, reconnect positive battery cable and then negative battery cable. Working from side of driver's air bag, turn ignition switch from OFF position to ON position. Observe AIR BAG indicator light to ensure system is functioning properly. AIR BAG indicator light should illuminate for 7 seconds and go out.
STEERING WHEEL & HORN PAD
Note. Special air bag assembly attaching bolts are coated with a bonding agent. Discard old bolts after removal and replace with NEW bolts.
COMBINATION SWITCH
Note. Individual switches can be replaced without removing combination switch base assembly from steering shaft.
TURN SIGNAL SWITCH
See COMBINATION SWITCH .