Home ReviewsRefund
Home/Nissan/Altima/Nissan Altima L30 facelift (1999-2001)/Repair manual/Mechanical/Cooling System Bleeding
Contents Wiring diagrams Section: Mechanical All sections

Cooling System Bleeding Nissan Altima L30 facelift

Mechanical 2 illustrations ~125 words
  1. Move temperature control lever to HOT position. Loosen air relief plug. (Scheme 3)or (Scheme 4). Fill radiator. Tighten air relief plug.
  2. Install and tighten radiator cap. Operate engine until warm. Race engine 2 or 3 times under no load. Stop engine and allow it to cool. Remove radiator cap. Loosen air relief plug. Fill radiator. Tighten air relief plug.
  3. Install and tighten radiator cap. Operate engine until warm. Race engine 2 or 3 times under no load. Stop engine and allow it to cool. Remove radiator cap. Start engine. Fill radiator slowly to allow air in system to escape. Fill coolant reservoir.

Scheme 3

Scheme 3
Scheme 3

Scheme 4

Scheme 4
Scheme 4

Note. On Altima, engine and transaxle are removed as an assembly through bottom of engine compartment.