- Drain engine coolant.
- Remove lower radiator hose.
- Remove water inlet, then take out thermostat.
- Install thermostat with jiggle valve or air bleeder at upper side. Apply continuous bead of liquid gasket to mating surface of coolant inlet. After installation, rum engine for a few minutes and check for leaks.
Home/Nissan/Altima/Nissan Altima L30 (1997-1999)/Repair manual/Mechanical/Removal & Installation: Overview
Contents
Wiring diagrams Section: Mechanical- Removal & Installation
- Removal & Installation: Overview
- Removal & Installation: Diagnosis
- Removal & Installation: Removal & Installation
- Installation (1997 Pickup)
- Installation (1997 Pickup): Overview
- Installation (1997 Pickup): Removal & Installation
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Pin Voltage Charts
- Procedures
- Removal & Installation
- Restraints
- Seats
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems