LUBRICATION SPECIFICATIONS
| Material | Condition | Specification |
|---|
| Engine Oil (1) | Ambient Temperature Less Than -20°F (-29°C) To Over 100°F (38°C) | SAE 5W-30: API SH or SG |
| Engine Oil (1) | Ambient Temperature Above 0°F (-18°C) To Over 100°F (38°C) | SAE 10W-30: API SH or SG |
| Brake Fluid | All | DOT 3 |
| Power Steering Fluid | All | Dexron II ATF |
| Engine Coolant | All | Ethylene-Glycol Based Antifreeze |
| Automatic Transmission | All | Nissan Matic "D" or Dexron III/Mercon ATF |
| Manual Transmission (2) | Ambient Temperature Less Than -20°F(-29°C) Up To 104°F(40°C) | SAE 75W-90, 80W-90: API GL-4 |
| Manual Transmission (2) | Ambient Temperature Above 50°F (10°C) To Over 104°F (40°C) | SAE 140: API GL-4 |
| Differential Gear (3) | Ambient Temperature Less Than -20°F(-29°C) Up To 104°F(40°C) Ambient Temperature Above 50°F (10°C) To Over 104°F (40°C) | SAE 75W-90, 80W-90: API GL-5 SAE 140: API GL-5 |
| Fuel | All | Unleaded: 91 Octane Minimum |
| (1) SAE 5W-30 is preferred for all ambient temperatures. SAE 10W-30 may be used if the ambient temperature is above 0°F (-18°C). (2) SAE 75W-90 is preferable for ambient temperatures below 104°F (40°C). (3) SAE 80W-90 is preferable for ambient temperatures below 104°F (40°C). |
| (1) | SAE 5W-30 is preferred for all ambient temperatures. SAE 10W-30 may be used if the ambient temperature is above 0°F (-18°C). |
| (2) | SAE 75W-90 is preferable for ambient temperatures below 104°F (40°C). |
| (3) | SAE 80W-90 is preferable for ambient temperatures below 104°F (40°C). |
LUBRICATION SPECIFICATIONS
FLUID CAPACITIES
| Item | Condition | Specification (1) |
|---|
| Engine Oil | Drained, With New Filter | 4.0 Qts. (3.8L) |
| Engine Coolant | System & Reserve Drained | 7.25 Qts. (6.9L) |
| Automatic Transmission | Total (Overhaul) Capacity | 8.75 Qts. (8.3L) |
| Differential Gear Oil | Drained | 1.4 Qts. (1.3L) |
| Manual Transmission | Drained | 2.6 Qts. (2.5L) |
| Fuel Tank | Full Capacity | 17.1 Gal. (65L) |
| (1) Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. |
| (1) | Capacities are recommended or calculated levels. Always use dipstick (if available) to measure level. |
WHEEL TIGHTENING
Tighten wheel lug nuts to 72-87 ft. lbs. (98-118 N.m).
BATTERY SPECIFICATIONS
| CAUTION | When battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section. |
If battery is replaced, it should be of the same group number as shown on the original battery's label. All years and models use BCI group 24C batteries.
