Home/Mitsubishi/Lancer Evolution/Mitsubishi Lancer Evolution IX (2005-2007)/Repair manual/Heater, Air Conditioning and Ventilation (Lancer Evolution)/GENERAL DESCRIPTION

Contents

Section: Heater, Air Conditioning and Ventilation (Lancer Evolution)

GENERAL DESCRIPTION

SAFETY PRECAUTIONS

CONDENSER FAN AND RADIATOR FAN CONTROL

When operating the A/C switch

When operating the air outlet selection control knob

A/C COMPRESSOR CLUTCH RELAY ON CONDITIONS

CAUTION LABELS

INTRODUCTION TO HEATER, A/C AND VENTILATION DIAGNOSIS

HEATER, A/C AND VENTILATION DIAGNOSTIC TROUBLESHOOTING STRATEGY

SYMPTOM CHART

TECHNICAL DESCRIPTION (COMMENT)

TROUBLESHOOTING HINTS

DIAGNOSIS

CIRCUIT OPERATION

TECHNICAL DESCRIPTION — Part 1

TECHNICAL DESCRIPTION — Part 2

SPECIAL TOOLS

REFRIGERANT LEVEL TEST

RECEIVER DRIER TEST

COMPRESSOR DRIVE BELT ADJUSTMENT

CHARGING

METHOD BY USING REFRIGERANT RECOVERY AND RECYCLING UNIT

DISCHARGING SYSTEM

REFILLING OF OIL IN THE A/C SYSTEM

LOST CHARGE

LOW CHARGE

HANDLING TUBING AND FITTINGS

COMPRESSOR NOISE CHECK

ADJUSTMENT

BLOWER RELAY CONTINUITY CHECK

A/C COMPRESSOR CLUTCH RELAY, CONDENSER FAN RELAY (LO) AND (HI) CONTINUITY CHECK

IDLE-UP OPERATION CHECK

BLOWER SWITCH CONTINUITY CHECK

<< A >> MODE SELECTION DAMPER CABLE AND AIR MIX DOOR CABLE REMOVAL

REMOVAL AND INSTALLATION

<< A >> FLEXIBLE SUCTION HOSE AND LIQUID PIPE B DISCONNECTION

<< A >> BLOWER MOTOR REMOVAL

RESISTOR CHECK

BLOWER FAN AND MOTOR CHECK

OUTSIDE/INSIDE: AIR SELECTION DAMPER CONTROL MOTOR CHECK

<< A >> FLEXIBLE SUCTION HOSE, LIQUID PIPE B DISCONNECTION

<< B >> EVAPORATOR REMOVAL

>> A << EVAPORATOR INSTALLATION

INLET SIDE

OUTLET SIDE

<< A >> FLEXIBLE SUCTION HOSE AND FLEXIBLE DISCHARGE HOSE DISCONNECTION

<< B >> DRIVE BELT REMOVAL

<< C >> A/C COMPRESSOR REMOVAL

>> A << A/C COMPRESSOR INSTALLATION

COMPRESSOR MGNETIC CLUTCH OPERATION CHECK

>> A << FIELD CORE ATTACHMENT

>> B << SNAP RING INSTALLATION

>> C << SELF-LOCKING NUT INSTALLATION

>> D << AIR GAP ADJUSTMENT

REFRIGERANT TEMPRATURE SWITCH

<< A >> FAN SHROUD ASSEMBLY REMOVAL

<< B >> FLEXIBLE DISCHARGE HOSE / LIQUID PIPE A DISCONNECTION

>> A << CONDENSER INSTALLATION

CONDENSER FAN MOTOR CHECK

<< A >> LIQUID PIPE A, FLEXIBLE DISCHARGE HOSE, FLEXIBLE SUCTION HOSE, SUCTION PIPE, LIQUID PIPE B, DISCONNECTION

>> A << FLEXIBLE SUCTION HOSE INSTALLATION

FASTENER TIGHTENING SPECIFICATION

GENERAL SPECIFICATION

SERVICE SPECIFICATIONS

LUBRICANT

All sections

GENERAL DESCRIPTION Mitsubishi Lancer Evolution IX

Heater, Air Conditioning and Ventilation (Lancer Evolution)

GENERAL DESCRIPTION

The heater system uses a two-way-flow full-air-mix system that features high performance and low operating noise. It includes an independent face air blowing function. In addition, an air purifier has been included. RS is equipped with a heater. GSR is equipped with an air conditioner.