Engine Lubrication: Component Locations Mitsubishi Galant IX рестайлинг 2

SPECIAL TOOLS

SPECIAL TOOLS CHART TOOL TOOL NUMBER AND NAME SUPERSESSION APPLICATION MB991396 Oil filter wrench General service tool or MB991396-01 Removal and installation of engine oil filter (when using oil filter MD321589 and MD352627) MB992118 Oil pressure switch wrench - Removal and installation of engine oil pressure switch

Scheme 8

Scheme 9

1. Pull out the oil dipstick slowly and check that the oil level is within the marks on the oil dipstick.
2. Check that the oil is not excessively dirty, that there is no coolant or gasoline mixed in, and that it is sufficiently thick and slippery.

Scheme 10

Scheme 11

Scheme 12

1. Start the engine and allow it to warm up until the temperature of the coolant reaches 80 - 90°C (176 - 194°F). WARNING: Use care as oil could be hot.
2. Remove the engine oil filler cap.
3. Remove the drain plug to drain oil.
4. Install a new drain plug gasket so that it faces in the direction shown in the illustration, and then tighten the drain plug to the specified torque. Tightening torque: 39 ± 5 N.m (29 ± 3 ft-lb)
5. Refill the specified quantity of oil. Specified engine oil: Engine oils displaying ILSAC certification mark ("Starburst" symbol) or conforming to the API classification SM Total quantity: 4.3 dm 3 (4.52 quarts) NOTE: SAE 5W-20 engine oil is strongly recommended for optimum fuel economy and cold starting. SAE 10W-30 may be used when the normal operating temperature is above 38°C (100°F).
6. Install the engine oil filler cap.
7. Let the engine run for a few minutes.
8. Stop the engine, and then check the oil level using the oil dipstick after a few minutes.