BRAKE FLUID LEVEL SENSOR CHECK
The brake fluid level sensor is in good condition if there is no continuity when the float surface is above "MIN" and if there is continuity when the float surface is below "MIN".
Home/Mitsubishi/Eclipse/Mitsubishi Eclipse IV (2005-2008)/Repair manual/Mechanical - Hydraulic/Basic Brake System: Maintenance
Contents
Wiring diagrams Section: Mechanical - Hydraulic- Basic Brake System: Specifications
- Basic Brake System: Overview
- Basic Brake System: Diagnosis
- Basic Brake System: Removal & Installation
- Basic Brake System: Overhaul
- Basic Brake System: Maintenance
- Basic Brake System: Component Locations
- Basic Brake System: Other
- Abbreviations
- Airbag
- Antenna Systems
- Anti-Lock/traction Control
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Body Electrical
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Communication Devices
- Cooling Fan
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Control Systems
- Engine Performance
- Exhaust
- Fuel System
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- Heated Glass/defoggers
- Heater
- Hoist/jack
- Identification
- Ignition System
- Lubrication System
- Manual & Power Steering
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mode 6
- Parking Brake System
- Specifications
- Starter
- Steering
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Traction Control Disable
- Transmission
- Wheel & Tire System
