Contents Wiring diagrams Section: Procedures All sections

Maintenance Information: Specifications Mitsubishi Diamante I

WHEEL & TIRE SPECIFICATIONS

Tire pressure specifications are listed on a label attached near the door sill striker on the driver's door. Cold inflation pressure should not exceed the maximum values molded on the tire side wall. Tire inflation pressure may increase from 2 to 6 psi (14 to 41 kPa) during operation. DO NOT reduce this normal pressure build up.

WHEEL TIGHTENING

Tighten wheel lug nuts to 65-80 ft. lbs. (88-108 N.m).

BATTERY SPECIFICATIONS

CAUTIONWhen battery is disconnected, vehicles equipped with computers may lose memory data. When battery power is restored, driveability problems may exist on some vehicles. These vehicles may require a relearn procedure. See appropriate COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section.

If battery is replaced, new battery should be of the same group number as shown on the original battery's label.