- Note position of CMP sensor electrical connector. Remove CMP sensor. See CAMSHAFT POSITION SENSOR. Before removing synchronizer housing, set piston No. 1 to Top Dead Center (TDC).
- Apply reference marks on synchronizer housing and engine. Remove synchronizer housing hold-down bolt and clamp. Remove synchronizer assembly with intermediate shaft.
Home/Mercury/Sable/Mercury Sable III (1995-1999)/Repair manual/Removal & Installation/Removal (Except VIN S): Overview
Contents
Wiring diagrams Section: Removal & Installation- Removal & Installation
- Removal & Installation: Overview
- Removal & Installation: Removal & Installation
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic HVAC System
- Automatic Trans
- Axle Shafts
- Basic Trouble Shooting
- Body, Cab Control Systems
- Brakes
- Cabin Air Filter
- Charging System
- Check Lists
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Door Locks & Anti-Theft Systems
- Drive Cycles
- Driveline/axles
- DTC Index
- Electrical Component Locations
- Electronic Steering
- Emission Applications
- Engine
- Engine Controls - Tests W/codes - 3.0L: Diagnosis
- Engine Performance
- Exterior Lights
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Identification
- Manual & Power Steering
- Manual HVAC System
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Mode 6
- Oem General Information
- Pin Voltage Charts
- Procedures
- Removal & Installation
- Reset Procedures
- Restraints
- Seats
- Sensor Range Charts
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Sun Roof/t-Top/convertible Top
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance