Home/Mercury/Mountaineer/Mercury Mountaineer III (2005-2010)/Repair manual/Engine Control Systems/Acceleration Control System: Removal & Installation

Contents

Wiring diagrams Section: Engine Control Systems

All sections

Acceleration Control System: Removal & Installation Mercury Mountaineer III

Engine Control Systems

REMOVAL AND INSTALLATION

Disconnect the accelerator pedal electrical connector.
Remove the nuts and the accelerator pedal assembly. To install, tighten to 7 Nm (62 lb-in).
To install, reverse the removal procedure.

The adjustable accelerator pedal and adjustable brake pedal must be serviced as a unit. For additional information, refer to section «HYDRAULIC BRAKE ACTUATION»(ref-270961) .