Engine Ignition System: Removal & Installation Mercury Montego III

Removal and Installation

1. Remove the upper intake manifold. For additional information, refer to «ENGINE»(ref-233006) .
2. Disconnect the ignition coil electrical connectors.
3. Remove the ignition coil bolts. To install, tighten to 6 Nm (53 lb-in).
4. Remove the ignition coils.
5. To install, reverse the removal procedure. Apply a light film of Silicone Brake Caliper Grease and Dielectric Compound XG-3-A meeting Ford specifications ESE-M1C171-A to the inside of the coil boots before installation.