Installation (B3000)
| CAUTION | Failure to install the TP sensor in this manner may result in excessive idle speeds. |
- Slide the rotary tangs into position over the throttle shaft blade, then rotate the TP sensor.
- To complete installation, reverse remaining removal procedures. See «TORQUE SPECIFICATIONS»(ref-151901-S31341501772003010900000) .
Note. Numbers in parenthesis refer to numbers in illustration.
- Remove the accelerator control splash shield. (Scheme 6)
- Disconnect the Throttle Position (TP) sensor harness connector (1). (Scheme 213)
- Remove the bolts and the TP sensor (2). (Scheme 213)
- To install, reverse removal procedure. See «TORQUE SPECIFICATIONS»(ref-151901-S31341501772003010900000).
Scheme 213
Removal and installation information is not available from the manufacturer. For component locations (Scheme 178)
Removal and installation information is not available from the manufacturer. For component locations (Scheme 179)