TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|
| Brake Hose-To-Caliper Bolt | 16-21 (22-29) |
| Caliper Bracket Bolt (Front) | 37-50 (50-68) |
| Caliper Bracket Bolt (Rear) | 34-49 (46-66) |
| Caliper Lock Bolt (Front - M10) | 33-39 (45-53) |
| Caliper Lock Bolt (Front - M12) | 51-57 (69-78) |
| Caliper Lock Bolt (Rear) | 26-28 (35-39) |
| Master Cylinder Mounting Nut/Washer | 7-12 (10-16) |
| Parking Brake Bolt | 14-18 (19-25) |
| Parking Brake Cable-To-Caliper Nut | 12-16 (16-22) |
| Power Brake Unit Mounting Nuts | 14-18 (19-25) |
| Proportioning By-Pass Valve Tubing | 10-16 (13-22) |
| INCH Lbs. (N.m) |
| Bleeder Screw & Bleeder Cap | 53-78 (6-9) |
| Master Cylinder Reservoir Screw | 9-13 (1.0-1.5) |
| Master Cylinder Stop Screw & "O" Ring (Non ABS) | 18-22 (2.0-2.5) |
| Master Cylinder Stop Screw & "O" Ring (ABS) | 61-87 (7-10) |
| Proportioning By-Pass Valve Bolt | 70-104 (8-12) |
| Application | In. (mm) |
|---|
| Front (1) |
| Original Thickness | .04 (1) |
| Minimum Thickness (2) | .71 (18) |
| Rear (1) |
| Original Thickness | .04 (1) |
| Minimum Thickness (3) | .31 (8) |
| (1) Maximum lateral runout is .004" (.10 mm). (2) If using a brake lathe to machine rotor on vehicle, minimum thickness is .74" (18.8 mm). (3) If using a brake lathe to machine rotor on vehicle, minimum thickness is .33" (8.4 mm). |
| (1) | Maximum lateral runout is .004" (.10 mm). |
| (2) | If using a brake lathe to machine rotor on vehicle, minimum thickness is .74" (18.8 mm). |
| (3) | If using a brake lathe to machine rotor on vehicle, minimum thickness is .33" (8.4 mm). |
DISC BRAKE SPECIFICATIONS
