Installation
- To install, reverse removal procedure. Apply sealant to carrier mating flange. Align marks made during removal, and install axle shafts. Install differential. Raise transmission until engine and transmission are level.
- Position Power Plant Frame (PPF) in place. Install PPF-to-differential mounting spacer. Tighten bolts to specification. See «TORQUE SPECIFICATIONS»(ref-4734-S40781739572000072100000).
- Install and tighten PPF-to-transmission side mounting bolts. Ensure sleeve is installed into PPF housing block. Install spacer and bolts. Ensure reamer bolt is installed into front hole, and tighten bolt. (Схема №2) NOTE: Front PPF-to-differential side mounting bolt is a reamer bolt which aligns PPF. (Схема №2)
- Install transmission-to-PPF bracket. Install remaining PPF bolts. Refill differential with lubricant. Tighten all nuts and bolts to specification. See «TORQUE SPECIFICATIONS»(ref-4734-S40781739572000072100000). To complete installation, reverse removal procedure.
Note. Mark positions of all components before disassembly.
Note. Overhaul procedure for Limited Slip Differential (LSD) is not available.