REMOVAL & INSTALLATION
Note. Before disconnecting battery cable, obtain radio code number from customer and deactivate audio anti-theft system.
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section before disconnecting battery. |
Remove rear console assembly. Disconnect switch harness connector near shift lever. Remove switch screws. Remove switch. To install, reverse removal procedure.
Fully open window. Raise window until height of glass (measured at top rear edge) is as specified. See WINDOW HEIGHT SPECIFICATIONS table. Disconnect negative battery cable. Remove door trim panel. Remove window regulator and motor as an assembly. Securely position regulator arms in full-up position (if possible) to relieve spring pressure. Remove window motor from regulator. To install, reverse removal procedure.
| Application | In. (mm) |
|---|---|
| Miata | 7.5 (190) |
WINDOW HEIGHT SPECIFICATIONS