STARTER INTERLOCK SWITCH (CLUTCH START SWITCH)
Switch is mounted on bracket near top front of clutch pedal. Disconnect switch wiring connector. Using ohmmeter, ensure continuity exists between switch connector terminals when clutch pedal is depressed. If continuity does not exist, adjust or replace switch.
Solenoid
- Disconnect all wires from solenoid, including "M" wire between solenoid and starter. Using ohmmeter, ensure there is continuity between "S" and "M" terminals, and between "S" terminal and solenoid body. (Схема №1)and (Схема №2). If continuity does not exist between these terminals, replace solenoid.
- Ensure continuity does not exist between "M" and "B" terminals. If continuity exists between these terminals, solenoid is shorted. Replace solenoid.
OVERRUNNING CLUTCH PINION DRIVE
Hold overrunning clutch housing and turn pinion gear by hand. If pinion turns in both directions, clutch is faulty. Replace clutch. DO NOT clean overrunning clutch with solvent, as it is packed with grease and sealed by manufacturer.