- Disconnect oxygen sensor. Remove heat shields. Disconnect downpipe from exhaust manifold. Remove exhaust manifold.
- To install, reverse removal procedure. Ensure all mating surfaces are clean and flat. Install NEW gasket to cylinder head. Tighten manifold bolts evenly to specification, starting from center bolt and alternating outward. See TORQUE SPECIFICATIONS TABLE at the end of this article.
Contents
Wiring diagrams Section: Mechanical- Removal & Installation: Overview
- Removal & Installation
- Removal & Installation: Diagnosis
- Removal & Installation: Removal & Installation
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Airbag
- Anti-Lock/traction Control
- Application
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (Mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Driveline/axles
- Electrical
- Electrical Component Locations
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Headlight Doors
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Mirrors
- Oem General Information
- Pin Voltage Charts
- Procedures
- Removal & Installation
- Restraints
- Specifications
- Starter
- Steering
- Steering Column
- Steering Column Switches
- Steering Gear
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Timing Belt
- Traction Control Disable
- Transmission
- Wheel Alignment
- Windows
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance