REMOVAL & INSTALLATION
| CAUTION | When battery is disconnected, vehicle computer and memory systems may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION section before disconnecting battery. |
Wrap tape around end of screwdriver. Carefully pry main switch out of door with screwdriver. Disconnect electrical connector. To install, reconnect electrical connector. Press main switch into door until lock tabs engage.
Wrap tape around end of screwdriver. Pry sub-switch out of door with screwdriver. Disconnect electrical connector. To install, reconnect electrical connector. Press sub-switch into door until lock tabs engage.
Fully open window. Raise window until height of glass (measured at top rear edge) is as specified. See WINDOW HEIGHT SPECIFICATIONS table. Disconnect negative battery cable. Remove door trim panel. Remove window regulator and motor as an assembly. Securely position regulator arms in full-up position (if possible) to relieve spring pressure. Remove window motor from regulator. To install, reverse removal procedure.
| Application | In. (mm) |
|---|---|
| MPV | 7.1 (180) |
WINDOW HEIGHT SPECIFICATIONS