| A/C Compressor Bracket Bolt | 28-38 (38-52) |
| Axle Shaft Bracket-To-Cylinder Block Bolt | 32-46 (43-62) |
| Baffle Plate Bolt | 14-18 (19-25) |
| Camshaft Sprocket Bolt | 90-103 (122-140) |
| Clutch Release Cylinder Bolt (M/T) | 12-17 (16-23) |
| Connecting Rod Bolt |
| Step 1 | 16-20 (22-27) |
| Step 2 | Additional 83-97 Degrees |
| Coolant Outlet Bolt | 14-18 (19-25) |
| Crankshaft Pulley Bolt | 116-122 (157-166) |
| Cylinder Head Bolt (1) |
| Step 1 | 17-19 (23-26) |
| Step 2 | Additional 85-95 Degrees |
| Step 3 | Additional 85-95 Degrees |
| Engine Mount Bracket Above Water Pump-To-Cylinder Block Bolt | 32-45 (43-61) |
| Engine Mount Crossmember Retaining Bolt/Nut | 50-69 (68-93) |
| Engine Mount-To-Engine Mount Crossmember Nut | 55-77 (75-104) |
| Engine Mount-To-Transaxle Case Nut | 27-38 (37-52) |
| Engine-To-Transaxle Case Bolt | 66-86 (90-116) |
| Exhaust Manifold Bolt/Nut | 12-16 (16-22) |
| Flywheel/Flexplate Bolt | 45-49 (61-67) |
| Friction Gear Nut | 51-57 (69-78) |
| Front Exhaust Pipe-To-Exhaust Manifold Nut | 28-38 (38-52) |
| Front Suspension Crossmember Bolt | 69-97 (94-131) |
| Fuel Rail Bolt | 14-18 (19-25) |
| Intake Manifold Bolt/Nut | 14-18 (19-25) |
| Knock Sensor | 15-25 (20-34) |
| Lower Control Arm Ball Joint To-Steering Knuckle Through-Bolt | 32-43 (43-58) |
| Lower Cylinder Block Bolt (2) |
| Bolt "A" |
| Step 1 | 17-19 (23-26) |
| Step 2 | Additional 75-85 Degrees |
| Bolt "B" |
| Step 1 | 17-19 (23-26) |
| Step 2 | Additional 65-75 Degrees |
| Bolt "C" |
| Step 1 | 13-15 (18-20) |
| Step 2 | Additional 55-65 Degrees |
| Bolt "D" | 14-18 (19-25) |
| No. 1 Idler Pulley Bolt | 28-38 (38-51) |
| No. 2 Idler Pulley Bolt | 28-38 (38-51) |
| Oil Cooler-To-Oil Filter Adapter Nut | 19-25 (25-34) |
| Oil Pan Bolt |
| Long Bolt | 14-18 (19-25) |
| Short Bolt | (3) * |
| Oil Pump Bolt | 14-18 (19-25) |
| Power Steering Pump Bracket Bolt | (4) * |
| Power Steering Pump Pulley Nut | 37-43 (52-58) |
| Relief Valve Plug | 42-50 (57-68) |
| Right (Timing Belt Side) Engine Mount |
| Nut | 55-75 (74-102) |
| Through-Bolt | 63-86 (86-116) |
| Shift Rod-To-Transaxle Bolt (M/T) | 12-17 (16-23) |
| Spark Plug | 11-16 (15-22) |
| Stabilizer Bar Link Nut | 32-45 (43-61) |
| Stabilizer Rod-To-Transaxle Bolt (M/T) | 23-34 (31-46) |
| Starter-To-Transaxle Case Bolt | 24-34 (32-46) |
| Tensioner Pulley Bolt | 28-32 (38-44) |
| Throttle Body Bolt/Nut | 14-18 (19-25) |
| Tie Rod End Nut |
| MX-6 & 626 | 32-41 (43-55) |
| Millenia | 41-59 (55-80) |
| Timing Belt Tensioner Bolt | 14-18 (19-25) |
| Transaxle Mount & Bracket Bolt/Nut | 50-68 (67-92) |
| Water Pump Bolt | 14-18 (19-25) |
| Wheel Lug Nut | 65-87 (88-118) |
| INCH Lbs. (N.m) |
| Air Pipe-To-Intake Manifold Bolt | 71-97 (8-11) |
| Camshaft Bearing Cap Bolt (5) | 97-124 (11-14) |
| Crankshaft Position Sensor Bracket Bolt | 71-97 (8-11) |
| Cylinder Block Valley Cover Bolt | 71-97 (8-11) |
| Fuel Injector Retainer Bolt | 18-35 (2-4) |
| Oil Jet | 27-45 (3-5) |
| Oil Pump Body Cover Bolt | 54-80 (6-9) |
| Pick-Up Tube Bolt | 71-97 (8-11) |
| Pressure Regulator Bolt | 62-89 (7-10) |
| Seal Plate Bolt | 71-97 (8-11) |
| Timing Belt Cover Bolt | 71-97 (8-11) |
| Valve Cover Bolt (6) | 45-80 (5-9) |
| Water Pump Pulley Bolt | 71-97 (8-11) |
| (1) Tighten bolts to specification in sequence. (Схема №7) (2) Identify bolts and tighten bolts to specification in proper sequence. (Схема №38) (3) Tighten bolts to 71-97 INCH lbs. (8-11 N.m). (4) Tighten 2 upper bolts on front of bracket to 23-34 ft. lbs. (31-46 N.m). Tighten lower bolt on front of bracket to 14-19 ft. lbs. (19-26 N.m). Tighten bolt on rear of bracket-to-cylinder block to 24-33 ft. lbs. (32-45 N.m) (5) Tighten bolts to specification in sequence. (Схема №22) (6) Tighten bolts to specification in sequence. (Схема №11) |
