Home ReviewsRefund
Home/Mazda/Millenia/Mazda Millenia I (1994-2000)/Repair manual/Adjustments/Engine Controls - Adjustments - 2.3L: Adjustments
Contents Wiring diagrams Section: Adjustments All sections

Engine Controls - Adjustments - 2.3L: Adjustments Mazda Millenia I

Adjustments ~117 words

Inspection & Adjustment Using NGS Scan Tool

  1. Connect New Generation Star (49 T088 0A0) scan tool to data link connector 2 located under left side of instrument panel, right of steering column. (Схема №3) Turn ignition on. Using scan tool, select PID/DATA MONITOR AND RECORD.
  2. Select TP V to monitor. Manually rotate throttle linkage and check voltage readings. See TP SENSOR VOLTAGE table.
  3. If voltage readings are not as specified, close throttle. Loosen TP sensor screws. Rotate TP sensor until voltage indicates as specified. Tighten TP sensor screws. Open throttle valve fully a few times. Recheck TP sensor voltage. If TP sensor voltage is not as specified, replace TP sensor.

More articles — Engine Controls - Adjustments - 2.3L