Transfer Component Assembly Procedure
Note. Before applying silicone sealant, completely clean off any old silicone sealant and remove any oil or grease. After applying silicone sealant, install the drive gear case within 10 min. After connecting the sealing area, leave it for 30 min. or more, then add transfer oil.
- Clean the alignment surface of the front carrier and drive gear case, and lightly apply silicone sealant.
- Assemble the transfer component. Tightening torque 19-27 N.m {2.0-2.7 kgf.m, 14.1-19.9 ft.lbf}
- Install the oil cooler.
- Tighten the oil cooler installation bolt with a O-ring. Tightening torque 23.5-29.4 N.m {2.4-2.9 kgf.m, 17.4-21.6 ft.lbf}
- Tighten the drain plug with a new washer.
Tightening torque
39.2-58.8 N.m {4.0-5.9 kgf.m, 29.0-43.3 ft.lbf}