Wheels and Tires Removal/Installation
- The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N.m {9.0-12.0 kgf.m, 65.0-87.0 ft.lbf}.
Power Steering Components Removal/Installation
- If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III, M-V or equivalent (e.g. Dexron(R)III), bleed the fluid lines, and inspect for leakage after the procedure has been completed.
Suspension Arm Removal/Installation
- Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered to the ground and unloaded. NOTE: Unloaded: Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack, and tools are in designated position.