- Ensure battery is fully charged and engine is at normal operating temperature. Allow engine to cool for 10 minutes. Remove spark plugs and disconnect ignition coil primary connector.
- Remove spark plugs and fully open throttle valve. Attach compression gauge and crank engine until maximum pressure is reached at each cylinder. Lowest cylinder pressure should be at least 75% that of the highest cylinder pressure.
Contents
Section: Adjustments- Engine Compression
- Valve Clearance
- 4-Cylinder Ignition Timing
- Idle Speed & Mixture
- Fast Idle Cam
- Choke Valve
- Secondary Throttle Valve
- 4-cylinder Idle Speed
- B2200
- B2600i, Mpv (4-Cyl.), & 323
- MX-6 & 626
- Dashpot Adjustment
- 4-cyl. (fuel Injected)
- Throttle Position Sensor (TPS)
- 323 Non-Turbo
- B2600i, Mpv (4-CYL.), MX-6 & 626
- Abbreviations
- Accessory Drive Belts
- Adjustments
- Application
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Basic Trouble Shooting
- Brakes
- Charging System
- Check Lists
- Clutches Manual & Hydraulic
- Computer Relearn
- Cooling Fan
- Cooling System (mechanical)
- Cruise Control Systems
- Diagnostic Connector Locations
- Differentials & Drive Axles
- Driveline/axles
- Electrical Component Locations
- Electronic Suspension
- Emission Applications
- Engine
- Engine Performance
- Fuses & Circuit Breakers
- Gauges & Instrument Panels
- General Servicing - All Makes
- Heated Glass/defoggers
- Heater
- Identification
- Manual & Power Steering
- Manual HVAC System
- Manual Trans
- MAP Guidelines
- Mechanical
- Mechanical - Hydraulic
- Metric Conversions
- Oem General Information
- Pin Voltage Charts
- Procedures
- Removal & Installation
- Reset Procedures
- Specifications
- Starter
- Steering
- Steering Column
- Suspension Front
- Suspension Rear
- Testing & Diagnostics
- Theory & Operation
- Timing Belt
- Traction Control Disable
- Transmission
- Wheel Alignment
- Wiper/washer Systems
- Wiring Diagrams - Engine Performance