Home ReviewsRefund
Home/Mazda/3/Mazda 3 BL (2008-2011)/Repair manual/Anti-Lock/traction Control/Dynamic Stability Control: Maintenance
Contents Wiring diagrams Section: Anti-Lock/traction Control All sections

Dynamic Stability Control: Maintenance Mazda 3 BL

Anti-Lock/traction Control

BRAKE FLUID PRESSURE SENSOR INITIALIZATION PROCEDURE

WARNINGIf the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.
  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2.
  3. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. When using the IDS (laptop PC) Select "Chassis". Select "ABS/DSC". Select "Sensor Initialization". When using the PDS (Pocket PC) Select "Module Tests". Select "ABS". Select "DataLogger". Select "MCYL_S_CAL".
  4. Perform the initialization procedure according to the directions on the screen.
  5. Drive the vehicle.
  6. After 5 min or more of driving, verify that the DSC system is normal.

More articles — Dynamic Stability Control