STARTER SPECIFICATIONS
| Application | Specification | |
|---|---|---|
| Brush Length | ||
| Standard | .59 in. (15.0 mm) | |
| Minimum | .35 in. (9.0 mm) | |
| Brush Spring Tension | 4.8-6.2 Lbs. (2.2-2.8 kg) | |
| Commutator Diameter | ||
| Standard | 1.38 in. (35.0 mm) | |
| Minimum | 1.34 in. (34.0 mm) | |
| Commutator Undercut (1) | ||
| Standard | .028 in. (.70 mm) | |
| Minimum | .008 in. (.20 mm) | |
| Commutator Runout (Maximum) | .002 in. (.05 mm) | |
| (1) Depth of groove between each segment of commutator. | ||
| (1) | Depth of groove between each segment of commutator. |
STARTER SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Coolant By-Pass Pipe Bolt | 13 (18) |
| Fuel Inlet-To-Fuel Main Tube | 22 (30) |
| Intake Manifold Bolt/Nut | 13 (18) |
| Rear Coolant By-Pass Joint Nut | 13 (18) |
| Starter Bolt | 27 (37) |
| Terminal Nut | 13 (18) |
| Throttle Body Bolt/Nut | 13 (18) |
| INCH Lbs. (N.m) | |
| End Cover-To-Brush Holder Screw | 35 (4) |
| End Cover-To-Magnetic Switch Housing Screw | 35 (4) |
| Starter Housing-To-Magnetic Switch Screw | 80 (9) |
| Starter Trough Bolt | 80 (9) |
TORQUE SPECIFICATIONS