Steering System: Removal & Installation Lexus RX II

REPLACEMENT

HINT

COMPONENTS: See STEERING COLUMN ASSY (POWER TILT & TELESCOPIC)

1. PRECAUTION (See AIR BAG RESTRAINT SYSTEMS )
2. SEPARATE BATTERY NEGATIVE TERMINAL (See AIR BAG RESTRAINT SYSTEMS )
3. REMOVE FRONT DOOR SCUFF PLATE LH (See INSTRUMENT PANEL/METER )
4. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSY LOWER(See INSTRUMENT PANEL/METER )
5. REMOVE INSTRUMENT PANEL AIR BAG ASSY LOWER NO. 1 (See AIR BAG RESTRAINT SYSTEMS )
6. REMOVE MULTIPLEX TILT & TELESCOPIC ECU Disconnect the connectors from the multiplex tilt and telescopic ECU. Using a socket wrench (+), remove the 2 screws and multiplex tilt and telescopic ECU.
7. INSTALL MULTIPLEX TILT & TELESCOPIC ECU Using a socket wrench (+), install the 2 screws. Torque: 1.5 N.m (15 kgf.cm, 13 in.lbf) Connect the connectors to the multiplex tilt and telescopic ECU. NOTE: The wire harness between the telescopic motor and ECU has same shape connectors at both ends. When installing them, connect the connectors with the same color.
8. INSTALL INSTRUMENT PANEL AIR BAG ASSY LOWER NO. 1 (See AIR BAG RESTRAINT SYSTEMS )
9. INSPECT SRS WARNING LIGHT (See x SYSTEM OPERATION CHECK )