GENERATOR SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Exposed Brush Length | |||
| Standard | .413 in. (10.5 mm) | ||
| Limit (Minimum) | More Than .177 in. (4.5 mm) | ||
| Rotor | |||
| Resistance (1) | 2.3-2.7 ohms | ||
| Slip Ring Diameter | |||
| Standard | .559-.567 in. (14.2-14.4 mm) | ||
| Minimum | .551 in. (14.0 mm) | ||
| Generator Regulated Output | |||
| Amperage | |||
| Without Load | 10 Or Less Amps | ||
| With Load | 30 Or More Amps | ||
| Voltage | 13.2-14.8 Volts | ||
| (1) Measured @ 68°F (20°C). | |||
| (1) | Measured @ 68°F (20°C). |
GENERATOR SPECIFICATIONS
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Fan Fluid Coupling Nut | 21 (29) | ||
| Generator Mounting Bolt | |||
| Bolt | 29 (39) | ||
| Nut | |||
| 8-mm | 11 (15.5) | ||
| 10-mm | 29 (39) | ||
| Generator Pulley Nut | 81 (110) | ||
| Power Steering Pump Pulley Bolt | 13 (17) | ||
| INCH Lbs. (N.m) | |||
| Battery Wire Terminal Nut | 87 (9.8) | ||
| Brush Holder Screw | 16 (1.8) | ||
| End Frame Bolt (1) | 51 (5.8) | ||
| Fan Shroud Bolt | 44 (5.0) | ||
| Generator Rear End Cover Nut | 41 (4.6) | ||
| (1) May also be referred to as coil assembly. | |||
| (1) | May also be referred to as coil assembly. |
TORQUE SPECIFICATIONS