Rear Speed Sensor Lexus LX J100 рестайлинг

Scheme 200

Scheme 201

Scheme 202

1. Disconnect the speed sensor connector.
2. Remove the clamp bolt from the upper control bracket. Torque: 13 N.m (130 kgf.cm, 9 ft.lbf)
3. Remove the 6 resin clips, holding the sensor wire harness from the frame, upper control arm and axle housing.
4. Remove the mounting bolt and speed sensor. Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

INSTALLATION

Installation is the reverse order of removal (See REMOVAL ).

AFTER INSTALLATION, CHECK SPEED SENSOR SIGNAL (see «PRE-CHECK» ).

See also:
• REMOVAL