| CAUTION | If ECM replacement is instructed in following testing, always ensure ECM harness connector and ground circuit are okay. If either are suspect, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION. |
Circuit Description
Stoplight signal is used to detect when brakes have been applied. ECM uses this signal to control fuel cut-off. DTC is set if stoplight switch does not turn off when vehicle is being driven. Possible causes are
- Short in stoplight switch signal circuit.
- Faulty stoplight switch.
- Faulty ECM.
Diagnostic Aids
Using scan tool, read freeze frame data. Freeze frame records engine conditions when malfunction is detected.