FLUID TYPE & CAPACITY
| Application | Capacity - Qts. (L) |
|---|
| GS300, GS430 & LS430 | 1.4 (1.3) |
| IS300 | 1.3 (1.2) |
| RX300 | .90-1.0 (.85-.95) |
DIFFERENTIAL FLUID CAPACITY
Use API GL-5 gear oil . For operation in temperature above 0°F (-18°C) use SAE 90. For operation in temperature below 0°F (-18°C) use SAE 80W-90 or 80W.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|
| Center Bearing Support Bolts | 27 (37) |
| Differential Attaching Bolts |
| GS300 & GS430 |
| Front | 105 (142) |
| Rear | 90 (122) |
| LS430 |
| Front | 108 (147) |
| Rear | 105 (142) |
| Differential Breather Plug | 15 (21) |
| Differential Carrier Retainer | 16 (22) |
| Differential Cover Bolts | 35 (47) |
| Differential Bearing Cap |
| IS300 | 63 (85) |
| RX300 | 58 (79) |
| Drain & Filler Plug | 36 (49) |
| Drive Axle Bolts | 61 (83) |
| Drive Shaft Adjusting Nut | 39 (53) |
| Drive Shaft-To-Companion Flange Bolts | 58 (79) |
| Exhaust Center Pipe Bolts (GS300 & GS430) | 14 (19) |
| Exhaust Front Pipe Bolts | 32 (43) |
| Heat Shield Bolts | 48 (65) |
| Oxygen Sensor | 32 (44) |
| Pinion Flange Center Nut (Maximum) (1) |
| GS300, GS430 & LS430 | 362 (490) |
| IS300 | 249 (338) |
| RX300 | 174 (235) |
| Ring Gear Bolts |
| GS300, GS430 & LS430 | (2) 47 (64) |
| IS300 & RX300 | 71 (97) |
| INCH Lbs. (N.m) |
| Front & Rear Crossmember Brace Bolts | 106 (12) |
| (1) Ensure pinion bearing preload is set to specification. See COMPANION FLANGE & OIL SEAL under REMOVAL & INSTALLATION. (2) Turn additional 60-90 degrees after tightening to specification. |
| (1) | Ensure pinion bearing preload is set to specification. See COMPANION FLANGE & OIL SEAL under REMOVAL & INSTALLATION. |
| (2) | Turn additional 60-90 degrees after tightening to specification. |
