SERVICE DATA
| Starter assembly | Standard current: 190 A or less at 11.5 V |
|---|---|
| Starter armature assembly | Standard resistance: Segments - Segments: Below 1 ohms Armature - Commutator: 10kohms or higher |
| Standard diameter: 35.0 mm (1.378 in.) Minimum diameter: 34.0 mm (1.339 in.) Standard undercut depth: 0.7 mm (0.028 in.) Minimum undercut depth: 0.2 mm (0.008 in.) Maximum commutator's runout: 0.05 mm (0.0020 in.) | |
| Starter yoke assembly | Standard resistance: Lead wire - Field coil: Below 1 ohms Field coil end - Field frame: 10 kohms or higher |
| Brush length | Standard length: 15.0 mm (0.590 in.) Minimum length: 10.0 mm (0.394 in.) |
| Starter brush holder assembly | Standard resistance: Positive brush holder - Negative brush holder: 10 kohms or higher |
| Standard spring installed load: 21.5 to 27.5 N (2.2 to 2.8 kgf, 4.8 to 6.2 lbf) | |
| Starter magnetic switch assembly | Standard resistance: Terminal 50 - Terminal C: Below 1.0 ohms Terminal 50 - Switch body: Below 2.0 ohms |
| Starter relay | 3 - 5: 10 kohms or higher 3 - 5: Below 1ohms (when battery voltage is applied to terminals 1 and 2) |
| Starter cut relay | 3 - 5: 10 kohms or higher 3 - 5: Below 1ohms (when battery voltage is applied to terminals 1 and 2) |
| Engine switch | Pushed: 7 (SS1) - 5 (GND) Below 1 ohms Pushed: 2 (SS2) - 5 (GND) Below 1 ohms Not pushed: 7 (SS1) - 5 (GND) 10 kohms or higher Not pushed: 2 (SS2) - 5 (GND) 10 kohms or higher |
TORQUE SPECIFICATIONS
| Part Tightened | N*m | Kgf*cm | Ft.*lbf | |
|---|---|---|---|---|
| Starter x Engine | Bolt | 37 | 377 | 27 |
| Terminal 30 | 9.8 | 100 | 87 in.*lbf | |
| Terminal C | 6.5 | 66 | 57 in.*lbf | |
| Starter x Terminal lower cover | 10 | 102 | 7 | |
| No. 3 exhaust manifold heat insulator x Starter | 10 | 102 | 7 | |
| Starter commutator end frame x Brush holder | 3.8 | 39 | 33 in.*lbf | |
| Starter magnetic switch x Starter drive housing | 7.5 | 76 | 66 in.*lbf | |
| Starter commutator end frame x Starter drive housing | 6.0 | 61 | 53 in.*lbf | |