REMOVAL & INSTALLATION
| CAUTION | To prevent damage, pry out decorative trim pieces with a plastic tool or a screwdriver with a taped tip. |
Pry switch out of instrument panel. Disconnect electrical connectors. To install, reverse removal procedure.
- Disconnect negative battery cable. Pry cover away from upper speaker. Remove bezel from inner door handle by prying it out. Pry up the front edge of switch base plate, then pull it forward to remove it. Remove courtesy light.
- Remove the following 7 screws that secure door trim panel: Three screws at bottom of panel One screw under a cap, at rear edge of panel One screw under a cap, at top edge of door pocket One screw accessible through vent hole (upper right corner) One screw accessible through switch base plate hole.
- Pry door trim panel away from door to release retainer clips. Pull door trim panel upward to disengage it from door. Remove upper speaker. Remove screws and mirror assembly. To install, reverse removal procedure.
Disconnect negative battery cable. Apply a strip of protective tape to bottom of mirror housing so it will be protected when prying out bottom of mirror. Using a plastic tool or taped screwdriver, pry out bottom of mirror (2 clips at bottom of mirror glass secure it to motor assembly). Pull bottom of mirror upward until tabs at top of mirror disengage from motor assembly. To install, reverse removal procedure.
