Removal
Note. Work must be started after 90 seconds from the time the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.
- Disconnect negative battery cable.
- Loosen the pivot bolt, adjusting lock bolt, and adjusting bolt, and remove the drive belt. (Схема №7)
- Disconnect the generator connector. Remove the nut, and disconnect the generator wire. Disconnect the wire harness from the clip. Remove the pivot bolt, plate washer, adjusting lock bolt and generator. Remove generator.
Installation
- Install generator. Mount generator on the generator bracket with the pivot bolt and adjusting lock bolt. (Схема №7) Do not tighten the bolts yet. Connect the generator connector. Connect the generator wire with the nut.
- Install drive belt. Install the drive belt with the adjusting bolt. Using a belt tension gauge, measure the drive belt tension. See «BELT TENSION»(ref-198410-S09362170962011060700000).
- Tighten the pivot bolt and adjusting lock bolt. Torque: 56 N.m (570 kgf.cm, 41 ft.lbf) for pivot bolt, 18 N.m (180 kgf.cm, 13 ft.lbf) for lock bolt * After installing a belt, check that it fits properly in the ribbed grooves. Check by hand to confirm that the belt has not slip out of the groove on the bottom of the pulley. After installing a new belt, run the engine for about 5 minutes and recheck the belt tension.
- Connect negative (-) terminal cable to battery.
- Perform on-vehicle inspection. See «ON-VEHICLE INSPECTION»(ref-198410-S38923827392005101500000).