INSTALLATION Land Rover Range Rover L322

INSTALLATION

1. Install the lower arm. Locate the air spring in the lower arm. Tighten the nuts and bolts to 165 Nm (121 lb.ft).
2. Secure the wheel knuckle to the lower arm. Tighten the nut and bolt to 250 Nm (184 lb.ft).
3. Secure the air spring to the lower arm. Tighten the bolt to 7 Nm (5 lb.ft).
4. Secure the shock absorber to the lower suspension arm. Tighten the bolt to 110 Nm (81 lb.ft).
5. Secure the height sensor link. Tighten the nut to 19 Nm (14 lb.ft).
6. Install the LH stabilizer bar link. Install the special washer. Tighten the nuts to 100 Nm (74 lb.ft).
7. Repeat the procedure for the RH side.
8. Using the Land Rover approved diagnostic system, pressurize the air suspension. Refer to «Air Suspension System Depressurize and Pressurize»(/land-rover/range-rover/l322-2005-2009/remont/electronic-suspension/#vehicle-dynamic-suspension__air-suspension-system-depressurize-pressurize) .
9. Install the rear wheels and tires. Tighten the wheel nuts to 140 Nm (103 lb.ft).