Engine Ignition (4.2L): Removal & Installation Land Rover Range Rover III facelift

INSTALLATION

1. Install the spark plugs. Tighten the spark plugs to 25 Nm (18 lb.ft).
2. Install the ignition coil-on-plug. See «Ignition Coil-On-Plug»(ref-522647-S02054349052013011500000) .
3. Install the remaining coil-on-plugs.
4. Connect the battery ground cable. Refer to «Specifications»(ref-522601) .

Scheme 2

Scheme 3

1. Disconnect the battery ground cable. Refer to «Specifications»(ref-522601) .
2. Remove the engine cover. Refer to «Engine Cover - 4.2L, Vehicles With: Supercharger»(ref-522605-S40342251052013011500000) .
3. Remove the ignition coil cover. Release from the 2 clips.
4. Disconnect the ignition coil-on-plug electrical connector.
5. Remove the ignition coil-on-plug. Remove the bolt. Remove and discard the seal.

1. To install, reverse the removal procedure. Tighten the bolt to 6 Nm (4 lb.ft).