Multifunction Electronic Modules: Removal & Installation Land Rover Range Rover III facelift 2

INSTALLATION

1. Install the information and entertainment lower bracket. Install the screws.
2. Install the information and entertainment module. Connect the optical connector. Connect the electrical connectors.
3. Install the information and entertainment module upper bracket. Tighten the bolts to 10 Nm (7 lb.ft).
4. Install the LH floor stowage compartment. Install the nuts.
5. Install the trim clip securing the front loadspace trim panel LH to the floor stowage compartment.
6. Install the lower turn fastener, securing the front loadspace trim panel to the floor stowage compartment.
7. Install the LH finisher trim panel. Install the turn fasteners.
8. Install the luggage tie down ring. Tighten the bolt to 25 Nm (18 lb.ft).
9. Lower and secure the spare tire loadspace trim panel.
10. Install the loadspace trim panel, floor stowage compartment LH access cover.
11. Install the access panel to the loadspace trim panel LH.
12. Connect the battery ground cable. For additional information, refer to «Specifications»(ref-514850) .
13. Using the Land Rover approved diagnostic system, follow the on-screen instructions and configure the information and entertainment module.