INSPECT
Front wheel
Scheme 5
Scheme 6
- Check harness is correctly routed and secured. Ensure harness shows no sign of damage or chafing.
- Check speed sensor is fully inserted to the correct position. Check reluctor ring condition and ensure it is free from debris.
- Check harness is correctly routed and secured. Ensure harness shows no sign of damage or chafing.
- Check speed sensor is fully inserted to the correct position. Check reluctor ring condition and ensure it is free from debris.
ROAD TEST
There are two purposes for conducting a road test. Firstly, to ensure the work completed within the dealership meets the standards required as laid down by dealership processes. Secondly, for a skilled technician to assess the general condition of the vehicle and report any conditions that the customer should be made aware of.
| CAUTION | Two wheel dynamometer tests must not be carried out. Four wheel dynamometer tests must be restricted to 3 mph (5 kph). |
- Drive vehicle on a short road test. Check all vehicle systems for correct operation. Pay particular attention to: Engine Noise Gearbox Noise Suspension Noise Body Noise Braking System Operation Gear Selection Engine Performance
- Where possible, check for correct operation of Hill Descent Control (HDC) system. This should not be carried out if excessive journey time is required.
- After road test, carry out a final inspection of the vehicle on vehicle ramps.
- Check all underbonnet fluid levels and top-up if necessary.